POLAR CuttingSystem PACE 300

POLAR CuttingSystem 300 PACE

Efficient cutting system characterized by highly-automated processes in medium-size

The POLAR CuttingSystem PACE 300 automates finishing processes of non-printed or prepared materials.

The word "PACE" stands for "Polar Automation for Cutting Efficiency" and includes the following automation components:

The Workflow:

Transomat TR 3 BL automatically pulls the material being cut from the stack onto the Transomat pallet and the Autotrans gripper-loading system takes it and transports it to the high-speed cutter rear table.

The Autoturn turning gripper with automatic aligning gauge is the centre of the PACE cutting system. The gripper system turns the ream on the rear table, either 90 or 180 degrees, to the right or left-hand side. Then an automatic gauge positions the ream. The cut is released automatically. In this way, undivided reams can be cut without any operator. If further cuts are needed, the operator continues the cutting job and turns the individual products manually.

A POLAR Autotrim high-speed cutter, which automatically removes the cutting waste, is a precondition for this highly automated PACE cutting system.

The unloading Transomat makes it much easier to unload the high-speed cutter. This optimizes the entire workflow. The intermediate and final products are manually pushed onto the Transomat transport pallet. In automatic cycles, they are precisely stacked on the pallet.

POLAR CuttingSystem PACE 300
Components / Technical Data Medium size
Paper size cm 75 x 106
Transomat BL Type TRB 150-3
Gripper systems Type Autotrans and Autoturn
High-Speed Cutter Model: POLAR N 137 AT
Transomat E Type TRE 130-4


POLAR Transomat for loading a high-speed cutter

Transomat for loading

automate your loading and unloading processes.

Gripper loading system

Gripper loading systems

for the automatic loading of high-speed cutters directly onto the rear table.

High-Speed Cutter POLAR N 115 PRO HD

High-Speed Cutters

POLAR high-speed cutters are the key components in finishing.

Unloading with POLAR Transomat

Transomat E

When high-speed cutters need to be unloaded, Transomat units are a performance-enhancing alternative to stack lifts.

Content Management by   Inter Red